Workspace Flow
Workspace has several steps. It is best to go through them in order.
1. Donor Wallet
Create or import the donor wallet.
Until the donor is ready, other steps may be unavailable.
2. Select Action
Choose what you want to do:
- Remove Delegation, to clear an EIP-7702 delegation
- Custom TX Builder, to build the transfers by hand
- Permit Rescue
- DeBank Withdraw
3. TX Builder
The site builds the transaction payload.
If required data is missing, the build button will be disabled. Usually the UI explains what needs to be added.
Keep two similar names apart. TX Builder is this step, the third one: it hosts whichever panel the action you picked at step 2 needs, whichever action that is. Custom TX Builder is one of the four actions you pick at step 2, and this step can host its panel too. The names are close, but a step and an action are different things.
4. TX Simulator
Simulation checks the transaction before sending.
If simulation succeeds, you can move to donor funding.
If simulation fails, understand the error first — unless it reports that the check did not finish, which establishes nothing and simply asks to be run again.
5. Fund Donor
The site shows how much funding the donor needs.
Fund the donor and refresh the balance.
6. TX Sender
This is the final step. The site sends the transaction.
Before sending, check all details. After sending, watch the logs and tx hash.
Can You Go Back?
Yes, but after changing important data, old simulation/funding/send results may become outdated.
If you changed network, recipient, keys, or action type, rebuild and simulate again.
Next
- Rescue Actions — which action to choose.
- Simulation, Funding, and Sending — the last three steps.
- Glossary — what the terms mean.
